Motorola ES400 Data Wedge Setup
Click on the Data Wedge symbol in the lower right of the screen
Div Select Basic Configuration
Div Click on Basic Format
Div Select Prefix to Data
Div Enter the "$" symbol into the available field, and click Save
Div Select Suffix to data
Div Enter the $ symbol into the available field, and click Save
Div Click Back
Div Click Exit
Div You will be prompted with a Scripting Confirmation screen, click OK
Div Click Ok and you will be taken back to the devices home screen
Div
Motorola ES400 Data Wedge Feed Back Setup
Since X Mobile provides the tones for a good and bad scan you will need to turn off the feedback in the Data wedge.
Click on the Data Wedge symbol in the lower right of home the screen
Div Select Basic Configuration
Div Select the Barcode input option
Div - Select the option for Camera Scanner Driver
Div Select Feedback from the list
Div Select Good decode
Div Make sure all the options are unchecked. Clicking on an option will check and uncheck it. Once you have made sure they are all unchecked, click on Back
Div Select Bad decode
Div Make sure all the options are unchecked. Clicking on an option will check and uncheck it. Once you have made sure they are all unchecked, click on Back
Div Click Back
Div Scroll down, and select Back
Div Select Back
Div Select Exit
Div You will be prompted with a Scripting Confirmation screen, click OK
Div Select OK in the bottom right corner to take you to the device's home screen
Div
Now the set up of the Data wedge, and scanner feedback has been successfully set up. For a walk through on setting up X Mobile please see the following Knowledge base article. Installing X Mobile on a Windows Mobile Device (KB18)
If there are no 'wedge' options try navigating through the device menus for Data Collection > Specified Scanner > Symbology Options > Preamble/Postamble.
If you have any questions Please log into our support site at https://support.cxtsoftware.com, and enter a support ticket.
Page Properties | ||
---|---|---|
| ||
|
...